Product Specification for Approval

Customer: LCSC

Product Description: ALUMINUM ELECTROLYTIC CAPACITORS

Specifications: See list on page 3

Sincerity P/N: See list on page 3

Customer P/N: /

Product Brands: Sincerity (Trademark)

Production Date: 2024/10/21

Product Attributes

• Brand: Sincerity
• Origin: Sichuan, China

Technical Specifications

Note:

• CAP/DF: at 120Hz, 252
• L.C: 6.3~120V.DC, I0.01CV or 3A, whichever is greater; 160~550V.DC, I0.02CV+25A (C = CAP., V = WV), After 2 minute with rated working voltage applied.

Product Overview

This specification covers EH series Radial Type Aluminum Electrolytic Capacitors. The specifications are established in consultation with JIS-C-5101 and JIS-C-5141.

Test Environment

Unless otherwise specified, the standard range of atmospheric conditions for making measurements and tests are as follows: Ambient temperature: 252C, Relative humidity: 655%.

Product Characteristics

Electrical Characteristics

• Rated voltage and Operating Temperature: -40~105 (6.3~120V.DC)
• Capacitance: Test frequency: 120Hz 20%, Measuring circuit: Series equivalent circuit, Measuring voltage: 1Vrms. Criteria: Capacitance tolerance: 20%
• Dissipation Factor: Test conditions are the same as Capacitance. Criteria: See Table 1.
• Leakage Current: Conditions: The rated voltage shall be applied across the capacitors and its protective resistor which shall be 100010%. The leakage current shall then be measured after an electrification period of 2 min. Criteria: DC: 6.3~120V.DC, I0.01CV or 3uA, whichever is greater (I: Leakage Current (), C: Capacitance (F), V: Rated voltage (V)).
• High and Low Temperature Characteristic: Conditions: Step 1: 202, Step 2: -40-3+0 for 120min, Step 3: 202, Step 4: 105-0+3 for 120min. Criteria: Step 2: Impedance value comparison with step 1, not more than Table 2 requires. Step 4: Capacity value change compared to step 1 is within 20%.
• Surge Voltage Test: Conditions: Apply the surge voltage listed in Table 3, charge for 305 seconds, discharge for 3305 seconds as a cycle, a total of 1000 cycles. Test temperature: 15~35. Then store under standard atmospheric conditions for thermal stability, after which measurements are made. Criteria: Capacitance Change: Within 20% of initial value. Dissipation Factor: Not more than 200% of the specified value in Table 1. Leakage Current: To satisfy No. 4.1.4.

Mechanical Characteristics

• Tensile strength of termination: Conditions: At Room temperature, along the lead line down the direction of the terminal on the application of tension (as shown in the following table), maintain 51 seconds.