SMD Inductor

This SMD Inductor, part number PSPMAA0603-2R2M-ANF, is designed for general electronic equipment applications. It is suitable for use in AV equipment, communication equipment, home appliances, entertainment equipment, computer equipment, personal devices, office equipment, measuring equipment, and industrial robots, under conventional operating and usage conditions. The product is manufactured by PROD TECHNOLOGY CO., LTD. / E-LIVEN TECHNOLOGY CO., LTD. in Taiwan.

Product Attributes

• Brand: PROD TECHNOLOGY CO., LTD. / E-LIVEN TECHNOLOGY CO., LTD.
• Origin: Taiwan
• Part Number: PSPMAA0603-2R2M-ANF

Technical Specifications

Electrical Characteristics

• All test data referenced to 25 ambient.
• Typical Heat Rating DC Current causes approximately T of 40.
• Typical Saturation DC Current causes Lo to drop approximately 35%.
• Operation Temperature Range: -55 ~ 125.
• Part temperature (ambient + T) should not exceed 125 under worst-case operating conditions.

Mechanical Specifications

Reliability Specifications

• Solder heat proof: Preheating: 180 10 90 seconds, Soldering: 255 5 for 3 1 sec. Inductance change within 5%.
• Shock: Without mechanical damage with 981m/s (100G) shock. Inductance change within 5%.
• Vibration: Vibration frequency: 10Hz to 55Hz to 10Hz 60 seconds cycle, Vibration time: 2 hours. Inductance change within 5%.
• Endurance Reliability:
  • -25, (30 mins) -> room temp. (5 mins) -> 125, (30 mins) -> room temp. (5 mins) 100 cycles. Inductance change within 5%.
  • Apply IDC current @ 85 ambient Duration: 1000 hrs. Inductance change within 5%.
  • Apply IDC current @ 60 ambient Humidity: 90~95 Duration: 1000 hrs. Inductance change within 5%.
  • Storing Temp. -25 2 for total 1,000 +4/-0 hours. Inductance change within 5%.
  • Storing Temp. 125 2 for total 1,000 +4/-0 hours. Inductance change within 5%.

Product Precautions

• Product shelf life is 12 months under storage conditions: temperature 5~40, humidity within 10~80% RH. Oxidation of product terminals may occur beyond the shelf life.
• Do not use or store in extreme environments (high salt, strong acid, strong alkali, strong radiation, etc.).
• Preheat the product before soldering. The temperature difference between preheating and soldering is recommended to be within 150.
• When reworking after soldering, follow the specified conditions. Excessive heating or repeated rework may lead to product failure.
• After soldering to the PCB, avoid applying residual stress due to PCB deformation. This can cause cracking, detachment, and failure.
• Do not expose the product to cleaning agents, alcohol, or other liquids, as they may corrode the product and cause failure.
• Product temperature will rise with increasing current. Ensure sufficient margin in the design.
• Excessive static electricity can cause permanent damage. Implement static protection measures.
• Do not touch any part of the product during power-on to prevent electric shock.
• As a magnetic product, consider potential mutual interference with surrounding components during design.
• This product is suitable for general electronic equipment. For applications requiring high safety and reliability, or where product failure could endanger life or property, consult the company before use.