SAMXON GF Series Aluminum Electrolytic Capacitors

Product Overview
This specification applies to polar Aluminum electrolytic capacitors (foil type) designed for use in electronic equipment. Manufactured by MAN YUE ELECTRONICS COMPANY LIMITED under the SAMXON brand, the GF series capacitors meet IEC60384 standards. They are constructed with a single-ended, wound element impregnated with electrolyte, enclosed in an aluminum case, and sealed with end seal rubber, finished with a PET vinyl sleeve. These capacitors are suitable for general electronic equipment applications.

Product Attributes

• Brand: SAMXON
• Manufacturer: MAN YUE ELECTRONICS COMPANY LIMITED
• Series: GF Series
• Type: Polar Aluminum Electrolytic Capacitor (Foil Type)
• Construction: Single ended, wound element, aluminum case, PET sleeve
• Compliance: Meets IEC60384 standards
• Lead Material: Tinned CP wire (Pb Free)
• Terminal Material: Aluminum wire
• Sealing Material: Rubber
• Case Material: Aluminum case
• Sleeve Material: PET
• Separator Material: Electrolyte paper

Technical Specifications

Rated Voltages & Surge Voltages

Application Guidelines Summary

• Circuit Design: Electrical parameters vary with temperature and frequency. Consider these effects on leakage current, capacitance, and ESR. Avoid reverse voltage, over voltage, and exceeding maximum ripple current. Pulse current should not exceed 10 times the rated ripple current at 120Hz.
• Capacitor Mounting: Ensure proper hole spacing, avoid wiring patterns under the capacitor, and maintain clearance for pressure relief vents.
• Capacitor Handling: Verify polarity before insertion. Avoid dropping or using dented/crushed capacitors. Observe soldering temperature and time specifications.
• Circuit Board Cleaning: Use suitable cleaning solvents and ensure thorough drying. Avoid specific solvent groups that can damage the capacitor.
• Environmental Conditions: Do not store or use capacitors outside their rated temperature range, in high humidity, or exposed to toxic gases, ozone, radiation, or excessive vibration/shock.
• Emergency Procedures: In case of vent operation, immediately turn off equipment. Avoid contact with escaping electrolyte gas.
• Long Term Storage: Capacitors stored for over one year may require reconditioning by applying rated voltage in series with a current limiting resistor.