SAMXON GF Series Aluminum Electrolytic Capacitors

Product Overview
The SAMXON GF Series Aluminum Electrolytic Capacitors are polar, foil-type capacitors designed for use in electronic equipment. Meeting IEC60384 standards, these capacitors offer reliable performance with a wide operating temperature range of -40C to 105C. They are constructed with a tinned CP wire lead line, aluminum wire terminals, rubber sealing, aluminum case, and PET sleeve, ensuring durability and stable electrical characteristics. The GF series is suitable for general electronic applications requiring stable capacitance, low leakage current, and good ripple current handling capabilities.

Product Attributes

• Brand: SAMXON
• Series: GF Series
• Construction Type: Single ended, foil type
• Sleeve Material: PET
• Lead Line Material: Tinned CP wire (Pb Free)
• Terminal Material: Aluminum wire
• Sealing Material: Rubber
• Case Material: Aluminum
• Separator Material: Electrolyte paper
• Compliance: Meets IEC60384 standards

Technical Specifications

General Characteristics

• Standard Atmospheric Conditions for Measurement: Ambient temperature: 15C to 35C, Relative humidity: 45% to 85%, Air Pressure: 86kPa to 106kPa.
• Specific Measurement Conditions: Ambient temperature: 20C 2C, Relative humidity: 60% to 70%, Air Pressure: 86kPa to 106kPa.

Application Guidelines & Precautions

• Circuit Design: Electrical parameters vary with temperature and frequency. Designers should consider these variations. Avoid reverse voltage, over voltage, and exceeding maximum ripple current. Use appropriate series or parallel configurations.
• Capacitor Handling: Verify capacitance, rated voltage, and polarity before insertion. Avoid dropping or denting capacitors. Observe soldering temperature and time specifications. Avoid stress on leads during insertion and soldering.
• Circuit Board Cleaning: Use suitable cleaning solvents and temperatures. Avoid halogenated, alkali, petroleum-based solvents, xylene, and acetone unless specified. Ensure thorough drying after cleaning.
• Environmental Conditions: Do not store or use outside rated temperature ranges, in direct contact with water/oil, high humidity, toxic gases, ozone, radiation, or excessive vibration/shock.
• Electrical Precautions: Avoid touching terminals. Do not short circuit terminals.
• Emergency Procedures: In case of vent operation, turn off equipment immediately. Avoid contact with escaping electrolyte gas. Follow first aid procedures for eye/skin contact or ingestion.
• Long Term Storage: Leakage current may increase after long storage. Reconditioning may be required.
• Capacitor Disposal: Incinerate after crushing/puncturing or dispose of as solid waste, following local laws.