<
>
Specifications
Voltage Rating:
50V
Tolerance:
±20%
Temperature Coefficient:
-
Power(Watts):
30mW
Number of Turns:
-
Resistance:
50kΩ
Mfr. Part #:
RA1010N-1H-2016-B50K-000
Package:
SMD
Key Attributes
Model Number:
RA1010N-1H-2016-B50K-000
Product Description
10mm ROTARY POTENTIOMETER
A 10mm rotary potentiometer designed for various electronic applications. This component offers precise control over resistance and is built to withstand specific environmental and mechanical conditions.
Product Attributes
- Brand: G-Switch Electronics Science and technology Co.,Ltd
- Part Name: RA1010N
- Origin: (Dongguan, China)
Technical Specifications
| Category | Item | Specifications | Description |
| Environment | Operating temperature range | -10+70C | |
| Storage temperature range | -25+75C | ||
| Test conditions (Standard) | Ambient temperature: 535C Relative humidity: 4585% Air pressure: 8601060mbar | () | |
| Test conditions (Reference) | Ambient temperature: 202C Relative humidity: 6070% Air pressure: 8601060mbar | () | |
| Mechanical Characteristics | Total rotational angle | 27010 | |
| Rotational torque | 10~70gf.cm | ||
| Rotational speed | 60/1 sec. | ||
| Push and pull strength of knob | 0.5kgf static load for 3 sec. (No abnormality in electric characteristics and operating feeling) | ||
| Knob wobble | 0.6xL/30 mm p-p max. (L: Knob diameter) | ||
| Shaft stopper strength | 0.6Kgf-cm max. | ||
| Electrical Characteristics | Nominal total resistance | B50K20% (Terminal 1-3) | (1-3 ) |
| Resistance law (Taper) | Refer to Taper graph shown | (Taper ) | |
| Insulation resistance | 100Mmin. at DC100 volts | ||
| Dielectric strength | Apply AC100 V for 1 min. (between individual terminals and case/shaft) | ||
| End resistance | 10max. (Terminal 1-2) 20max. (Terminal 2-3) | ||
| Noise | 100mV max. | ||
| Life (no load) | 5,000 cycles (1 cycle = CW270+CCW270)/6 sec. | ||
| Maximum operating voltage | AC 50V | ||
| Power rating | 0.03W | ||
| Lead-Free Soldering Specifications Manual Soldering: Max 350C, within 3 seconds. Automated/Semi-Automated Soldering: Flux specific gravity 0.82, foam height half PCB thickness, no flux on resistive element. Preheat time 2 minutes, PCB underside temp 100C. Solder dipping 260C, within 4 seconds. For plastic shaft with detents, set shaft to a detent position. Soldering process (manual or automated) must not exceed 1 time. Not recommended for reflow soldering. | |||
2410121450_G-Switch-RA1010N-1H-2016-B50K-000_C22466465.pdf
Request A Quote
Please Use Our Online Inquiry Contact Form Below If You Have Any Questions, Our Team Will Get Back To You As Soon As Possible
